Lippert Components Above Floor Slideout System - Manual (Page 6)

OPERATING SYSTEM
WARNING
FAILURE TO ACT IN ACCORDANCE WITH THE FOLLOWING MAY
RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
ALWAYS MAKE SURE THAT THE SLIDEOUT ROOM PATH IS CLEAR OF
PEOPLE AND OBJECTS BEFORE AND DURING OPERATION OF THE
SLIDEOUT ROOM.
ALWAYS KEEP AWAY FROM THE SLIDE RAILS WHEN THE ROOM IS BEING
OPERATED. THE GEAR ASSEMBLY MAY PINCH OR CATCH ON LOOSE
CLOTHING CAUSING PERSONAL INJURY.
KEEP STORED ITEMS IN COMPARTMENT CLEAR OF SLIDEOUT MOTOR,
MECHANISMS AND WIRING TO PREVENT INTERFERENCE OF SLIDEOUT
OPERATION.
INSTALL TRANSIT BARS (IF SO EQUIPPED) ON THE SLIDEOUT ROOM
DURING STORAGE AND TRANSPORTATION.
THE FAMILY OF LIPPERT ABOVE FLOOR SOFA SLIDE SYSTEMS IS
CONTROLLED BY A SWITCH MOUNTED ON THE COACH WALL, NORMALLY
LOCATED CLOSE TO THE ENTRY DOOR.
EXTENDING SLIDEOUT ROOM
1. Level Unit
2. Verify the battery is fully charged and hooked up to the electrical system.
3. Remove transit bars (if so equipped).
4. Press and hold the IN/OUT switch (Fig. 3 B ) in the OUT position until room
is fully extended and stops moving.
5. Release switch, which will lock the room into position.
NOTE: Only hold OUT switch until room stops.
RETRACTING SLIDE-OUT ROOM
1. Verify the battery is fully charged and hooked up to the electrical system.
2. Press and hold the IN/OUT switch (Fig. 3 C ) in the IN position until the
room is fully retracted and stops moving.
3. Release the switch. This will lock the room into position.
NOTE: Only hold IN switch until room stops.
4. Install the transit bars (if so equipped).
MANUAL OPERATION
The Lippert Above Floor Slideout System Motor is equipped with a Manual
Override system that allows you to extend or retract a room if the rooms do not
move when switch is pushed.
Check the troubleshooting guide on pages 9-11 for possible solutions before
using the backup auxiliary system.
6