Lippert Components Tent Camper Bike Rack - Manual (Page 4)

4
Fig. 6
Fig. 7a - Roadside
Place ROADSIDE Upright Base against the outside face of the “A” frame. Insert
the “C” bolts into the holes on the Base Bracket. Align front of the Base Bracket
with the rear of the Propane Tank Tray. (Fig. 6) Repeat procedure for
CURBSIDE Upright Base. Front wall profile on some units may interfere with this
mounting process.
Fig. 7b - Curbside
Installation
Correct Incorrect
“A” Frame
Front of Tent Camper
“A” Frame
A
B
Fig. 8b Fig. 8a
A
B
Front of Tent Camper
Place washers over threaded ends of the “C” Bolts. Thread Nylock Nuts onto “C”
Bolts until nuts are fully engaged but not firmly seated. (Figs. 7a & 7b) Fig. 8
shows the correct mounting alignment for the ROADSIDE and CURBSIDE
Uprights. Fig. 8a is CORRECT - the Uprights are square to the front of the tent
camper; 8b is INCORRECT. The Upright Bases are mounted to the OUTSIDE of
the “A” Frame. A is the CURBSIDE Upright; B is the ROADSIDE Upright.
NOTE: It is important to leave these brackets loose until the complete Tent
Camper Bike Rack is fully assembled. Failure to follow these instructions may
result in damage to components or assembly or cause serious personal injury or
death.