Living Sounds Audio SS26 - Manual

LSA SS26 Speaker Stand Assembly
ATTN: Tightening the top plate screws will take considerable force. Please make sure
the correct screws are being used in a given point, and that the screws are vertical
when installed.
A) Screw the spikes (8) into the bottom of the piano finished board (6)
B) Turn over the bottom board (6) and affix the oval tube (5) to it tightly by using the
short screws (7)
C) Insert the sand bag into the oval tube (5) for improved stability.
D) Place the small, round aluminum tube (4) in the sunken circle on the bottom board (6)
E) Place the top plate (2) on the support tubes and affix it with the longer supplied
screws ( 1).
Nashville · Tennessee · USA · [email protected] · www.thelsagroup.com