Longshine D410PT - Manual (Page 13)

Desktop Board Features
13
Processor
Intel Desktop Board D410PT includes a passively-cooled, single-core Intel Atom
processor with integrated graphics and memory controller. The processor is soldered
to the Desktop Board and is not customer upgradeable.
NOTE
The board is designed to be passively cooled in a properly ventilated chassis. Chassis
venting locations are recommended above the processor heatsink area for maximum
heat dissipation effectiveness.
System Memory
NOTE
To be fully compliant with all applicable Intel ® SDRAM memory specifications, the
board should be populated with DIMMs that support the Serial Presence Detect (SPD)
data structure. If your memory modules do not support SPD, you will see a
notification to this effect on the screen at power up. The BIOS will attempt to
configure the memory controller for normal operation.
The Desktop Board has two 240-pin DDR2 DIMM connectors with gold-plated contacts.
It supports:
• DDR2 800 MHz or DDR2 667 MHz unbuffered, non-registered DIMMs
• Serial Presence Detect (SPD) memory only
• Non-ECC memory
• Up to 4 GB of memory