Longshine LCS-6020 - Manual (Page 3)

Apr/01 3 6020-manual.doc
Windows 2000
Step 1：Start Windows 2000.
Step 2：Windows 2000 will inform you that it has found a “PCI I/O Card”. Click the “Next” button to
continue.
Step 3：Select “Search for a suitable driver for your device (Recommended)” and click the “Next”
button.
Step 4：Insert driver CD into the CD-ROM drive. Select “CD-ROM Drive” and click the “Next” button to
continue.
Step 5：Windows 2000 will automatically locate the driver in the driver diskette. Click the “Next” button to
continue.
Step 6：Click on the “Finish” button to start copying files from driver diskette.
Step 7：Follow the instructions to finish up the drive installation.
Windows NT 4.0
Using the existing hard disk controller in your system, you need to install the ATA/100 driver into Windows
NT first. Without ATA/100 driver support, hard drive attached to the ATA/100 IDE controller card can not
boot up Windows NT.
Installing drivers with existing Windows NT4.0:
Make sure Windows NT 4.0 is properly installed into your system first.
Step 1：Start Windows NT 4.0.
Step 2：Insert Driver CD into the CD-ROM drive.
Step 3：Select “Run” option in Windows NT.
Step 4：At the “Run” option, click on the “Browse” button.
Step 5：At the Browse for Folder window:
1. Select “CD-ROM Drive (D)”
2. Select NetMosMultiIODrivers.exe
3. Click on the Open button
Step 6：Finally, click the “OK” button.
Step 7：Follow the instructions to finish up the driver installation. Your system will automatically restart in
order to complete the driver installation.
Installing DOS Driver
Copy “D:\PCI_IO\NM98X5\DOS\NMDOSIN.EXE” to your hard disk and run it.