Pqc - v.92 phase 1 and phase 2 control, Syntax, Defined values – Longshine LCS-8156C1 User Manual
Page 115: Result codes, Reporting selected values, Reporting supported range of parameter values
AT Commands for CX930xx Modem Reference Manual
102752B
Conexant
3-91
+PQC - V.92 Phase 1 and Phase 2 Control
This command controls the global enabling or disabling of the V.92 shortened Phase 1
and Phase 2 startup procedures. This command is used in conjunction with the +PSS
command.
Syntax
+PQC=<value>
Defined Values
<value>
Decimal number corresponding to the selected setting.
0
Enable Short Phase 1, Short Phase 2, Short
Phase 3, and Short Phase 4. (Default.)
1 Not
supported.
2
Enable Short Phase 1 only.
3
Disable all Short Phases.
Result Codes
OK
0, 2, or 3 in V.92 Mode (+MS=V.92)
ERROR Otherwise
Reporting Selected Values
Command: +PQC?
Response: +PQC:
<value>
Example: +PQC:
0
Reporting Supported Range of Parameter Values
Command: +PQC=?
Response:
+PQC: (<value> range)
Example: +PQC:
(0-3)