Cortelco Colleague 2203 - Manual (Page 11)

To Dial A Phone Number In Memory
1.
Lift the handset and wait for a dial tone.
2. To dial an auto memory button (located on top of base) - Press
the desired auto memory button.
3. The number will be dialed automatically.
PAUSE BUTTON
The PAUSE button allows you to insert a 3.6-second pause in the dialing sequence. This
is particularly useful if you are connected to a PABX system where you must dial an
access code (usually the number 9) to obtain an outside line. It can also be used when
storing numbers in memory locations to insert a delay in the dialing sequence.
MESSAGE WAITING LAMP
The Message Waiting Lamp will light when a message is waiting at a properly equipped
PABX or telephone central office. This switch located under plastic memory index
cover allows the phone to be configured for 90V message waiting on T/R (tip/ring, the
red/green wires) or Y/B (the yellow/black wires).
T/R Y/B
If this switch is in T/R Position then the message waiting lamp also serves as visual ring
indicator.
HANDSFREE BUTTON
The Handsfree button (HF) is used to go off-hook without lifting the handset.
SPEAKER VOLUME
Use the handsfree Speaker Volume slide control located on the right side of the
phone base to change volume control handsfree. This increased volume should allow
persons with hearing impairments to carry on normal conversations by adjusting the
receive volume to its proper level.
MUTE BUTTON
Press MUTE to speak without the person on the phone hearing your conversation. The
MUTE Indicator will light up and remain lighted until you resume your conversation. To
resume your conversation, press MUTE. The MUTE indicator will go out and your call
can continue.
9