Cecilware CTR3.75 - Manual (Page 9)

9
Portability and storage
1. Keep the unit vertical when carrying the unit, the angle to the horizontal line should not
be over 50°, otherwise it will damage the compressor and affect normal operation of the
unit.
2. Adjust the height with all the four feet adjusted.
3. After moving the unit, let it stand for 30 minutes before switching it on.
4. Running: close the door and connect the power. Turn on the light switch. The
temperature should be suitable for normal use after half hour.
5. After connecting the power, the unit should be kept empty for one hour.
Maintenance
Disconnect the power supply before performing maintenance on the machine!
1. Keep the door gasket clean, remove it from the door and wash it. Dry and seal it as
before. Putting some talcum powder on the magnetic surface would prolong its service
life.
2. Light replacement: remove the top cover, take out the light, replace with a new light,
then mount it again.
3. Use a soft cloth and dip some water or soap (Non-caustic, neutral detergent is also
available) to clean the unit. Dry the unit after cleaning to avoid rust.
4. Do not use organic liquid, boiled water, washing powder or acid products to clean the
unit. Rinsing the case with water is not allowed. Do not use a hard brush to clean the
case.
5. If the unit will not be used for a long time, disconnect the power, clean it by following
the above steps, wipe off the water inside the case with a soft cloth. Discard the water
in the water plate.
Caution
1. The unit is not suitable for storage of blood, pharmaceutical products and biological
products
2. Do not place heavy articles on the top of the unit.