Luma Comfort MF18W - Manual (Page 7)

7
Say Goodbye to Ugly Products
A
SSEMBLY
I
NSTRUCTIONS
DO NOT plug in the fan before assembly. Carefully remove all packaging
materials and retain for future storage/use. Make sure there is no residual
foam left in any of the components. A wrench will be required to assemble this
misting fan.
S
TEP
1: A
SSEMBLING THE
S
TAND
P
OLE
& F
AN
B
ASE
1. Attach the coupling to the fan base using the 4 provided screws.
2. Loosen the height knob on the coupling and extend the inner tube to your
desired fan height.
3. Slide the cover ring down the outer tube so that it rests on top of the fan
base.
4. Make sure the height knob is fully tightened before proceeding onto the
next step.
S
TEP
2: A
SSEMBLING THE
F
AN
H
EAD
1. Locate the fan head and the support tube. These two parts will come fully
assembled.
2. Take the front mounting plate and the rear mounting plate and place
them in the center of the support tube. Use the provided screws to
connect the pieces together and make sure the connection is secure.
3. Firmly attach the support tube to the inner tube using the 2 mounting
screws and spring washers provided with the misting fan.