Make Noise Wogglebug User Manual
Page 3
Installation:
The Make Noise Richter Wogglebug is an electronic signal generator requiring 50mA of +/-12V regulated
power and properly formatted distribution receptacle to operate. It is designed to be used within the euro
format modular synthesizer system.
Go to
http://www.doepfer.de/a100_man/a100t_e.htm
for the details of this format.
To install, find 10HP of space in your euro-rack synthesizer system, confirm proper installation of included
power cable on backside of module (see picture below), plug the 16pin end power cable into the euro-rack
style power distribution board, minding the polarity so that the RED stripe on the cable is oriented to the
NEGATIVE 12 volt supply line. This is USUALLY at the bottom. On the Make Noise power bus board, the
negative 12 volt supply is indicated by the white stripe.
Please refer to your case manufacturers’ specifications for location of the negative supply.