Make Noise Wiard Wogglebug User Manual
Page 3
Installation:
The Make Noise Wiard Wogglebug is an electronic signal generator requiring 50mA of
+/-12V regulated power and properly formatted distribution receptacle to operate. It is
designed to be used within the euro format modular synthesizer system.
Go to
http://www.doepfer.de/a100_man/a100t_e.htm
for the details of this format.
To install, find 14HP of space in your euro-rack synthesizer system, confirm proper
installation of included power cable on backside of module (see picture below), plug the
16pin end power cable into the euro-rack style power distribution board, minding the polarity
so that the RED stripe on the cable is oriented to the NEGATIVE 12 volt supply line. This is
USUALLY at the bottom.
Please refer to your case manufacturers’ specifications for location of the negative supply.