Craftsman 137.21241 - Manual (Page 9)

8 9 8 9
CARTON CONTENTS
UNPACKING YOUR MITER SAW
To avoid injury from unexpected starting or
electrical shock, do not plug the power cord
into a source of power during unpacking and
assembly. This cord must remain unplugged
whenever you are working on the saw.
1. Remove the miter saw from the carton.
IMPORTANT: Do not lift miter saw by
the trigger switch handle. It may cause
misalignment. Lift machine by the built-in
carry handle.
2. Place the saw on a secure stationary work
surface.
3. Separate all parts from the packing material.
Check each of the illustrations shown below
to make certain all items are accounted for,
before discarding any packing material.
If any part is missing or damaged, do not
attempt to assemble the miter saw, or plug in
the power cord until the missing or damaged
part is correctly replaced. To avoid electric
shock, use only identical replacement parts
when servicing double insulated tools. Call
1-800-4-MY-HOME for replacement parts.
WARNING
!
WARNING
!
Hold-Down Clamp
Dust Bag
Miter Saw
Miter Table Handle
Blade Wrench
Extension Wings
Long-bottom Supports
Upper Legs
Lower Legs
Short-upper Supports
Long-upper Supports
Short-bottom Supports
Foot Pads Hardware Bag
R
Rear Extension Stay
Batteries
Hex Key