MF Digital DVD-5912 (Rev: 03/05/01) - Manual (Page 21)

CD-3706/P
Operator’s Guide
Document Revision: 030501.1 5000D Series
Operator’s Guide
Document Revision: 060102
Page 20
Creating A Hard Disk Image
The 5000D Series comes equipped with an internal hard disk drive, which
can be used to store copies of master discs for later recording or comparing.
Each master is saved as a single image file. Up to four images can be stored
on the hard disk at one time.
A hard disk image is useful as a convenient way of copying standard master
discs. For example, create hard disk images for three or four master discs
which are needed on a regular basis, and access them to make copies as
required.
Creating A Single Hard Disk Image
Although the 5000D Series’ internal hard disk can store up to four images
of master discs, it is sometimes prudent not to use this Multiple Image
feature and only allow one image to be created and stored. For example,
using a single image simplifies the copying process. This reduces the
chance that an operator might make copies of the wrong discs by selecting
the incorrect hard disk image.
To create a single hard disk image, the steps are as follows:
•
From the main operating screen depicted below:
S E L E C T C O P Y O R C O M P A R E
•
Press the “COPY” key. The screen will now read:
F R O M H D ?
•
Press the “STOP/NO” key. The screen will now read:
C O P Y T O H D ?
•
Press the “START/YES” key. The screen will now read in sequence:
WA I T I N G F O R D R I V E S R E A D Y