MIDI Solutions Relay - Manual (Page 4)

CLEAR SETTINGS
DUMP SETTINGS
LINK SETTINGS
To clear all of the Relay's settings, send it the following System Exclusive programming command:
It is recommended to send the Clear Settings command to the Relay prior to programming the unit to ensure that all
previous settings are cleared.
To dump all of the Relay's current settings, send it the following System Exclusive message:
Upon receipt of this command the Relay will dump its current settings to the MIDI Out.
To link together all of the Relay's Note and Control Change settings, send the Relay the following programming
command:
is set as follows:
= 00: Link OFF - each Note and Control Change setting operates independently
= 01: CLOSED Link - relay closes only if conditions of all Note and Control Change settings are in the
closed state
= 02: OPEN Link - relay opens only if conditions of all Note and Control Change settings are in the open
state
The link setting also has an effect on the power-up state of the relay. When link is OFF, the relay will power up in the
state in which it was previously powered down (powering up has no effect on the relay). When set to CLOSED link,
the relay will power up in the open state in order to prevent the relay from closing until all messages to close it are
received. When set to OPEN link, the relay will power up in the closed state in order to prevent the relay from opening
until all messages to open it are received.
F0 00 00 50 06 00 F7
F0 00 00 50 06 10 F7
F0 00 00 50 06 05 aa F7
aa
aa
aa
aa
PROGRAMMING COMMANDS
4