MIDI Solutions Router - Manual (Page 4)

CLEAR SETTINGS
DUMP SETTINGS
ROUTER SETTING PRIORITY
To clear all of the Router's settings, send it the following System Exclusive programming command:
It is recommended to send the Clear Settings command to the Router prior to programming the unit to ensure that all
previous settings are cleared.
To dump all of the Router's current settings, send it the following System Exclusive message:
Upon receipt of this command the Router will dump its current settings to the MIDI Out.
The Router will accept up to 10 settings. If more than 10 settings are sent to the Router, the oldest setting is
discarded to make room for the most recent setting. The Router gives the most recent setting priority over all previous
settings. For example, if the Router is first programmed to route all note messages on all channels to Out2, and then
programmed to route all note messages on channel 1 to Out1, then incoming note messages on channels 2 through
16 are sent to Out2, and incoming note messages on channel 1 are sent to Out1. It is also possible for the Router to
ignore priority. To set up the Router to process all of its settings, regardless of their priority, send it the following
command in place of the above Clear Settings command:
F0 00 00 50 01 00 F7
F0 00 00 50 01 10 F7
F0 00 00 50 01 00 01 F7
PROGRAMMING COMMANDS
4