MIDI Solutions F8 8-input MIDI Footswitch Controller User Manual
Page 12
12
TAP TEMPO
To program the F8 to operate in Tap Tempo mode sending MIDI timing clocks at a tempo corresponding to the taps of
one of its footswitch inputs, send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= Footswitch Input (00 for Fsw1 ... 07 for Fsw8)
To program the F8 to operate in Tap Tempo mode and also send a Note or Control Change message along with each
tap of the footswitch, send it the following System Exclusive programming command:
(
is optional)
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= Footswitch Input (00 for Fsw1 ... 07 for Fsw8)
= 01 to send Note, 02 to send Control Change
= Note number if
= 01, Control Change number if
= 02
= Note velocity if
= 01, Control Change value if
= 02
= MIDI channel of outgoing Note or Control Change message (see MIDI channel table at end)
is optional. If inserted, nothing is sent on release of the footswitch. If not inserted then a Note-Off (if
= 01)
or Control Change of value zero (if
= 02) is sent on release of the footswitch.
To program the F8 to operate in Tap Tempo mode and also respond to a Note or Control Change message (of
value>0) as a tap, send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= Footswitch Input (00 for Fsw1 ... 07 for Fsw8)
= 11 for Note, 12 for Control Change
= Note number if
= 11, Control Change number if
= 12
= MIDI channel of incoming Note or Control Change message (see MIDI channel table at end)
To program the F8 to operate in Tap Tempo mode and also to respond to a Note to specify the exact tempo in bpm,
send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= Footswitch Input (00 for Fsw1 ... 07 for Fsw8)
= offset added to Note number to obtain tempo
= MIDI channel of incoming Note message (see MIDI channel table at end)
To program the F8 to operate in Tap Tempo mode and also to respond to a Control Change message to specify the
exact tempo in bpm, send it the following System Exclusive programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= Footswitch Input (00 for Fsw1 ... 07 for Fsw8)
= Control Change number
= offset added to Control Change value to obtain tempo
= MIDI channel of incoming Control Change message (see MIDI channel table at end)
F0 00 00 50 24 0B ii F7
ii
F0 00 00 50 24 0B ii aa nn vv cc (00) F7
00
ii
aa
nn
aa
aa
vv
aa
aa
cc
00
aa
aa
F0 00 00 50 24 0B ii aa nn cc F7
ii
aa
nn
aa
aa
cc
F0 00 00 50 24 0B ii 21 bb cc F7
ii
bb
cc
F0 00 00 50 24 0B ii 22 nn bb cc F7
ii
nn
bb
cc