Milwaukee Tool 2445-20 Wiring 2000 - Manual

DOUBLE REDUCTION PISTOL GRIP TOOLS
58-03-1805
DATE
Oct. 2000
MILWAUKEE ELECTRIC TOOL CORP. 13135 WEST LISBON RD. BROOKFIELD, WIS.
BULLETIN
WIRING INSTRUCTIONS
TITLE
Drwg. 1
1 Brown ----- * Component of cord set or blade housing assembly.
2 Blue ----- * Component of cord set or blade housing assembly.
3 Black ----- ** Component of suppressor assembly.
4 Black ----- ** Component of suppressor assembly.
5White ----- *** Component of the brush card assembly.
6 Brown ----- *** Component of the brush card assembly.
7 Brown ----- *** Component of the brush card assembly.
8 White ----- *** Component of the brush card assembly.
9 Blue ----- *** Component of the brush card assembly.
10 Black ----- *** Component of the brush card assembly.
Terminals, Connectors and 1 or 2 End Wire Preparation
Wire
Color
Origin or
Gauge
Wire
No. Length
WIRING SPECIFICATIONS
BULK LEAD WIRE - BULLETIN NO. 58-01-0003
*
*
**
**
***
***
***
***
***
***
TERMINAL DESCRIPTION
Part No. Code Qnty.
T1 23-74-1060 4
Route white field wire #5 from brush card
between the post and the top of the rear
bearing bore first and then around bearing
bore as shown.
Route blue brush wire #9 and white
brush wire #8 through wire traps and
over rear bearing bore as shown.
Post
Insert black suppressor wires
#3 and #4 into holes marked
"1" and "2A" on the bottom of
the switch. Wires can go in
either hole.
Route white field wire #5 from the
brush card around the post in the
motor housing and into either hole
"1" on bottom of switch.
Insert brown wire #1, from the
cord or blade housing assembly,
into the hole marked "2ò" on the
bottom of the switch.
Insert blue wire #2, from the
cord or blade housing assembly,
into the hole marked "1ò" on the
bottom of the switch.
Fixed cord
shown
Post
.25 Minimum
Fixed Cord
Installation
For double insulated tools
with 2-wire quik-lok cords,
orientate the blade housing
assembly as shown and place
blue wire #2 first into the
bottom of the handle portion of
the motor housing.
Route brown
field wire #6
from the brush
card through any
of the three traps
in tab on the motor
housing, as shown.
Insert wire #6 into
hole "2" on the bottom
of the switch. (The
hole is marked with
a "2" on the side of
the switch).
Bottom
view of
switch
T1
T1
SCHEMATIC