Motion Pro 01-0152 - Manual

Assembly Instructions for Motion Pro 18 in.
Cable Display Rack #01-0152
CONTENTS: Bracket Arms 2
Wall Straps 2
Cable Racks 2
Display Cards 2
Hardware Kit 1
1. Bolt the wall straps to the back of bracket arms with flat head screws. Use holes marked on diagram “A” and
make sure both of the straps face the same directions with countersinks on the back.
2. Mount the cable racks to the frame work using 1” x 1/4” bolts. Use a large flat washer over rack hook and
acorn nut.
3. Adjust assembly so the racks and frame are square, (use of large square is helpful), then firmly tighten all the
bolts.
4. Slide in header card inserts. Note that cable package header cards may also be used.
5. Cable display rack should be mounted on wall so that mounting screws go into studs or something solid on
wall. We recommend using 6 screws at 1 1/2” long. Use holes marked “B” in diagram below.
6. You are invited to call Motion Pro, Inc. directly for questions on this display rack or other
Motion Pro,
Inc. products.
I01-0152 013114