Motion Pro 08-0134 - Manual

INSTRUCTIONS FOR USING THE MOTION PRO P/N 08-0134
TORQUE ADAPTER WRENCH
The Motion Pro torque adapter wrench is designed to be used with a torque wrench to accurately
tighten the cylinder base nuts on two-stroke engines that you cannot reach with a socket wrench.
How to use the Torque Adapter Wrench:
When you mount the adapter onto a torque wrench, it effectively lengthens the torque wrench.
Therefore, the torque value set on the torque wrench will not be the actual torque that you apply to
the fastener. Before using the torque adapter, you must recalculate the torque specification listed in
the engine’s service manual. To recalculate your torque wrench when using the Motion Pro
adapter, use the extension formula included with these instructions.
To make conversions from one form to another, use the following torque conversion table:
MULTIPLY BY TO OBTAIN
foot-pounds (ft-lb.) 1.356 Newton-meters
foot-pounds 0.1383 kilogram-meters
foot-pounds 12.0 inch-pounds
inch-pounds (in.-lb.) 0.01152 kilogram-meters
inch-pounds 0.1130 Newton-meters
inch-pounds 0.08333 foot-pounds
kilogram-meters (kg-m) 7.233 foot-pounds
kilogram-meters 86.79 inch-pounds
kilogram-meters 9.806 Newton-meters
Newton-meters (N-m) 0.7375 foot-pounds
Newton-meters 8.851 inch-pounds
Newton-meters 0.1020 kilogram-meters
After recalculating the torque specification, write it down here for future reference.
TORQUE ADAPTOR CORRECTION CHART
MODEL Ft.-lb. N-m
- OVER -
INSTRUCTIONS
Process Black
White White/Black MOTION PRO, INC. LOGO
Motion Pro, Inc.
867 American Street
Tel 650.594.9600 Fax 650.594.9610
www.motionpro.com
I08-0134 042009