Motion Pro 08-0135 - Manual

INSTRUCTIONS
Process Black
White White/Black MOTION PRO, INC. LOGO
Motion Pro, Inc.
867 American Street
San, Carlos, CA 94070
Tel: 650.594.9600 Fax: 650.594.9610
www.motionpro.com
Motion Pro Jumbo Chain Tool Part# 08-0135
Fig 1 Fig 2
Fig 3 Fig 4
I08-0135 07/2010
1 of 2
The Motion Pro Jumbo Chain Tool is designed for breaking roller chain from 520 through 630 and will rivet chains up to 530. The tool
may be used as a hand held device using the screw in handle. It may also be clamped in a bench vice or bolted to a workbench by
using two 3/8-24 bolts [not supplied]. If the tool is bolted to a workbench an air impact driver with 9/16” impact socket may be used.
EXTRACTOR
PIN
EXTRACTOR bOlT
EXTRACTOR
PIN GUIDE
PRESS PlATE
EXTRACTOR
PIN SPRING
bODy bOlT
TOOl bODy
TOOl HANDlE
TOOl
HANDlE
CAP
RIVET ANVIl
RIVET SET
Jumbo Chain Tool Components
08-0D35 EXTRACTOR PIN C08-135C EXTRACTOR BOLT
C08-135E EXTRACTOR PIN GUIDE C08-135F TOOL HANDLE
C08-001D EXTRACTOR PIN SPRING C08-135G RIVET ANVIL
C08-135A TOOL BODY C08-135H RIVET SET
C08-135b BODY BOLT C08-135K PRESS PLATE
TO bREAK CHAIN:
Assemble chain tool with Body Bolt,
Extractor Pin Guide, Spring, Extractor
Pin and Extractor Bolt in place (Fig 1).
Unscrew the Extractor Bolt from the
Body Bolt until the Extractor Pin has
withdrawn 1/8” into the Extractor Pin
Guide (Fig 2). Position the chain pin
to be removed between the hole in
the Extractor Pin Guide and the
corresponding hole in the Tool Body.
Using a 13/16” wrench, lightly tighten
the Body Bolt until the Extractor Pin
Guide rests securely against the side
plate of the chain (Fig 3). Next, while
holding the Tool Handle, tighten the
Extractor Bolt with a 9/16” wrench until
the Extractor Pin has pushed the chain
pin completely out the opposite side of
the chain (Fig 4). Unscrew the Extractor
Bolt and then the Body Bolt far enough
to remove the tool from the chain.