Motion Pro 08-0380 - Manual

INSTRUCTIONS
Process Black
White White/Black MOTION PRO, INC. LOGO
Motion Pro, Inc.
867 American Street
San, Carlos, CA 94070
Tel: 650.594.9600 Fax: 650.594.9610
www.motionpro.com
MOTION PRO ADJUSTABLE TORQUE WRENCH ADAPTER P/N 08-0380
90
°
FIGURE 1
No torque adjustment is required when
the wrench is at a 90° angle to the
handle of the torque wrench.
If you mount the wrench at a 90° angle
to the handle of the torque wrench no
calculations or adjustments to the specifi ed
torque value is required (see Fig. 1). This
means the torque that you want to put on
the fastener is equal to the reading from
your torque wrench.
When you mount the wrench parallel to the
handle of the torque wrench, it effectively
lengthens the torque wrench (see Fig.
2). Therefore, the torque value set on
the torque wrench will not be equal to the
torque that you apply to the fastener.
Before using the Adjustable Torque
Wrench Adapter, you must recalculate
the torque specifi ed in the service
manual. To recalculate your torque
use the torque adapter extension
formula on page 2.
TURN OVER
FIGURE 2
A torque adjustment
is required when the
wrench is parallel to
the handle of the
torque wrench.
A
L
The Motion Pro Adjustable Torque Wrench Adapter is designed to be used with a torque wrench to
accurately tighten fasteners that you cannot reach with a socket. This tool will work with most 6mm
(¼”) through 32mm (1 ¼”) combination wrenches and 6mm through 8mm Allen wrenches.
How to use the Adjustable Torque Wrench Adapter:
I08-0380 10/2012 Page 1