Motion Pro 08-0406 - Manual

I08-0406 09/2010
MOTION PRO UNI-SAG™ TELESCOPIC SAG SCALE P/N 08-0406
Thank you for purchasing this Motion Pro tool. With proper care and use this tool will provide you with years of
excellent service.
Correct suspension tuning is a must for reducing lap times and improving the handling characteristics of your motorcycle.
The first and single most important step is to measure and set your bike’s static and rider sag. This ensures you have the
proper spring rate and ride height for your bike, weight and riding style.
Figure 1
Setting Static Sag
1. Assemble your sag scale as shown in Fig. 1. Use
the appropriate seat bolt and rear axle adapter for
your application. If the rear axle adapter will not fit
into the rear axle remove the black plastic sleeve or
use the smaller diameter rear axle adapter supplied
with the kit. For late model KTM’s you can swap the
direction of your rear axle and use the silencer
mounting location or purchase our optional Fender
Clamp (P/N 08-0440).
Figure 2
2. Place the motorcycle on a stand to elevate the rear
wheel and allow the suspension to fully extend.
Attach the Uni-Sag™ to the rear axle and rear seat-
mounting nut (Fig. 2). Adjust the heim-joint with the
spacers so that the Uni-Sag™ is running straight up
and down when viewing it from the back of the bike.
You do not want the Uni-Sag™ leaning into or away
from the motorcycle or it will bind in use.
Figure 3
3. Loosen the rear axle adapter and slide the lower
tube down until the bottom of the recording marker is
at 0 mm (Fig. 3) and then tighten the rear axle
adapter. The Uni-Sag™ has now been zeroed to
record your static and race sag.