Motion Pro 08-0431 - Manual

I08-0430 1 of 2 09/2010
SNOWMOBILE TRACK CUTTING TOOL & STUD INSTALLATION TOOL
P/N 08-0430 & 08-0431
Thank you for purchasing the Motion Pro Track Cutting Tool, P/N 08-0430 and Stud Installation Tool, P/N 08-
0431. These tools will allow you to cut clean and precise holes in your snowmobile track and install studs with
a head diameter up to 1-1/4” and stud length up to 1-7/8”.
Using the Track Cutting Tool P/N 08-0430
1-Place the sled on a stand that will allow you to
rotate the track and allow easy access to the top of
the track below the tunnel.
2-Using a paint pen, mark the track all the way around
with the template supplied by the stud manufacturer.
3-Slide the Track Cutting Tool P/N 08-0430 over
the edge of the track and cut holes in the track by
rotating the handle of the tool clockwise. Rotate
the track to a new area and repeat the procedure
until all of the holes have been cut.
4-As you cut, the handle of the tool will capture and
store up to 150 track plugs. Remove the cap from the
handle of the tool to remove the plugs. Compressed
air can be used to remove any stuck plugs.
Remember to wear eye protection to protect yourself
from plug-projectiles!