Motion Pro 08-0467 - Manual

CHAIN BREAKER, PRESS AND RIVETING TOOL P/N 08-0467
Thank you for purchasing the Motion Pro Chain Breaker and Riveting Kit, P/N 08-0467. This kit will break, press on side
plates and rivet hollow-nosed master links on chains from #520 to size #532. For heavy-duty applications or for solid-
nosed riveting please refer to Motion Pro part number 08-0135 Jumbo Chain Tool and part number 08-0142 Quad
Stake Riveting Tool.
IMAGE A
A. Body, C08-058A D. Alignment Bolt, C08-058B G. Rivet Tip, 08-0062
B. Press Plates (set), 08-0067 E. 3.8mm Extractor Pin, 08-0061 H. Large Anvil, C08-058D
C. Handle F. Spring, C08-001D I. Push Bolt, C08-058C
• Read all instructions for each procedure before beginning. Improper use of the tool can cause breakage.
• Make sure the tool is clean and apply grease to all threads before assembling and using. This will help the tool
operate more smoothly and allow you to feel tension when using the tool.
• When breaking drive chains larger than #520, grind off the rivet head first to create a flat surface for
placement of the extractor pin tip. The flat surface will help to prevent the extractor pin from becoming misaligned
with the chain pin and contacting the chain side plate, therefore, significantly reducing the load on the tool and helping
to prevent damage to the extractor pin.
• All tightening procedures are to be performed by hand only, using a 14mm wrench. Do not use extensions or
power tools of any kind or the tool may be damaged.
Page 1 of 4
10/2010
A
I
C
F
E
G
H
B
D
I08-0467