MUTEC MC-3.3 Smart Clock VR - Manual (Page 9)

> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > 88
\
B E D I E N E L E M E N T E B E D I E N E L E M E N T E B E D I E N E L E M E N T E
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
Manual SDs-01 D 3.2.2003 17:45 Uhr Seite 3
CONTROL ELEMENTS
MC-3.3 Front Panel
1 POWER
This red LED lights up when the unit is switched on with the rear panel
POWER switch (on condition that the adjusted voltage matches your local
voltage).
2 MENU
Use this key to access the different function menus.
3 SELECT
Use this key to select a function from a specific function menu.
4 + 5 SD VIDEO + SD FORMAT
These two functional menus are working simultaneously together and let
you choose between different SD bi-level video standards (SD
VIDEO ) in com-
bination with different output formats and frame rates (SD FORMAT ).
6 + 7 HD VIDEO + HD FPS
These two functional menus are working simultaneously together and let
you choose between different HD tri-level video standards (HD
VIDEO ) in
combination with different frame rates (HD FPS ).
8 HD TEST PATTERN
Within this functional menu you can choose between different HD tri-level
test patterns which are available at the HD outputs as YPrPb component or
RGB signals.
For detailed specifications on all terminals,
refer to the »Pin Assignment of the
Connectors« and »Technical Data« in the
chapter APPENDIX.
Refer to the OPERATIONS chapter for more
information.
9
MC-3.3 Rear Panel
2 1
1 SD VIDEO OUT + HD VIDEO OUT
The outputs 1 to 6 of the upper interface row transmit SD bi-level sync
signals, the outputs 1 to 6 of the lower interface row transmit HD tri-level
video sync signals.
The lower row of interfaces can be also used to output different HD tri-
level test patterns two times, marked as HD TEST PATTERN OUT 1 + HD TEST
PATTERN OUT 2.
2 MAINS IN, Power Switch + Mains connector (IEC)
This is the main switch for switching the device on and off. Connect the
supplied IEC power cable to the device‘s mains connector. Make sure that
the power switch is turned off before connecting the device to your power
source finally. Line voltages within the range of 90…260 V with a frequency
of 50 or 60 Hz can be applied. The internal power supply will automatically
make all necessary adjustments.
4 3 2 5 1 6 7 8
Refer to the » Technical Data « section in the
APPENDIX for a full list of all available SD
and HD video format and frame rate combi-
nations.
Heed the SAFETY INSTRUCTIONS at the
beginning of this manual!