MUTEC MC-3.1 Smart Clock - Manual (Page 10)

\\\\\\\\\\\\\
C O N T R O L E L E M E N T S C O N T R O L E L E M E N T S C O N T R O L E L E M E N T S
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > 88
Manual SDs-01 E 3.2.2003 18:26 Uhr Seite 6
1 WC LK OUT 1 – 3
These 3 pairs of Word Clock outputs transfers either all standard Word
Clock rates as well as Word Clock x 256 for older digidesign ProTools™ sys-
tems. Their numbering is aligned to the corresponding functional menus on
the front panel. The individual BNC connectors of an output pair are marked
as A and B; this allows, for example, for a simple documentation of the con-
nected devices. For adjusting these outputs see chapter OPERATION.
2 AES/EBU OUT 5
These 2 AES/EBU outputs transmit a transformer-balanced electrical
blank-frame clock signal. Their numbering is aligned to the corresponding
functional menu on the front panel. The individual XLR connectors of this
output pair are marked as A and B; this allows, for example, for a simple
documentation of the connected devices.For adjusting these outputs see
chapter OPERATION.
3 S/PDIF OUT 6
This 2 S/PDIF outputs, available as optical and coaxial interfaces, transmit an
optical S/PDIF blank frame signal and an unbalanced electrical S/PDIF blank
frame signal. Their numbering is aligned to the corresponding functional
menu on the front panel. For adjusting these outputs see chapter OPERA-
TION.
4 MAINS IN, Power Switch + Mains connector (IEC)
This is the main switch for switching the device on and off. Connect the
supplied IEC power cable to the device‘s mains connector. Make sure that
the power switch is turned off before connecting the device to your power
source finally. Line voltages within the range of 90…260 V with a frequency
of 50 or 60 Hz can be applied. The internal power supply will automatically
make all necessary adjustments.
Heed the SAFETY INSTRUCTIONS at the beginning of this manual.
MC-3.1 SMART CLOCK SD Rear Panel
10
MC-3 SMART CLOCK Rear Panel
All audio clock outputs are the same as previously described for MC-3.
1 SD VIDEO
These 2 video outputs transmit a standard definition video sync reference
signal which can be PAL, NTSC or NTSC black + white. For adjusting these
outputs see chapter OPERATION.
Refer to the »Generatable Word Clock Fre-
quencies« and »Generatable AES/EBU and
S/PDIF Frequencies« sections in the APPENDIX
for a full list of all Word Clock, AES/EBU and
S/PDIF clock rates that can be generated.
4 3 2 1
1