Neu-F NF.2201 - Manual

©Copyright 2013 NEUSPEED ® All rights reserved.
Reproduction in whole or in part prohibited.
DOC.NF.2201 Rev. 11.15.2013
neuf • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neu-f.com
TORQUE ARM INSERT
2012-14 Fiat 500 Abarth
PART # NF.2201
INSTALLATION INSTRUCTIONS
PART LIST: 1 – Torque Arm Insert
TOOLS REQUIRED: 1 – E18 External Torx Wrench 2 – 18mm Wrench
or 14mm Box End Wrench
1. Park car on a flat, level surface capable of
supporting the vehicle’s weight on jack and jack
stands. Using the manufacturer’s recommended
lifting point(s), raise front of vehicle and support
with jack stands. NEVER WORK ON A
VEHICLE SUPPORTED ONLY WITH A JACK!
2. Unbolt rear most torque arm bolt using E18 or
14mm wrench. To completely remove bolt pull
down on exhaust pipe.
NOTE: Some aftermarket exhaust front pipe
may need to be unbolted from catalytic
converter and dropped down to allow removal of
bolt.
3. Only loosen front torque arm bolt using 18mm
wrench on bolt head and holding 18mm wrench
on nut.
4. Swing down torque arm.
5. Install Urethane insert from passenger side of
arm.
6. Push back up into place, install bolt and then
tighten both bolts.
7. Reconnect exhaust if necessary.