Neuspeed 65.10.64 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com
P-FLO COLD AIR INTAKE FOR 1993-99 GOLF III / JETTA III 2.0L 8V
PART # 65.10.60 & 65.10.64
INSTALLATION INSTRUCTIONS
PARTS LIST:
1 – HEAT SHIELD 2 – ¼” WASHER
1 – AIR FILTER 1 – PUSH FASTENER
1 – MINI FILTER (IF EQUIPPED) 1 – SHEET METAL SCREW
2 – ¼”-20 HEX BOLTS 1 – HOOD SEAL
2 – ¼”-20 NYLOC NUTS 1 – VACUUM CAP
TOOLS REQUIRED: 1 – FLAT SCREW DRIVER 1 – 7/16” WRENCH
1 – PHILIPS SCREW DRIVER 1 – 9/16” WRENCH
1 – DRILL MOTOR 1 – ¼” DIAMETER DRILL
1. First, disconnect mass air sensor from air box. Next,
unclip upper filter housing, remove air pump hose and
disconnect small vacuum line from manifold port. Cap
port with supplied plug and remove filter housing top.
Remove hot air tube between lower filter housing and
exhaust heat shield. Remove rubber ‘O’ rings that hold
air box to frame and remove lower filter housing.
2. Install mini-filter to air pump, if equipped.
3. Insert lower front portion of the shield under the
radiator support and slide bottom edge of shield into
slot between AC condenser line and chassis seam.
Rotate rear portion of shield down and into position,
making sure any hoses and/or electrical lines are routed
through cut outs.