Neuspeed CHIP.20T.17.PW11-12 - Manual

NEUSPEED® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com • E-mail: [email protected]
VW MK VI
ECU REMOVAL INSTRUCTIONS
(GTI 2.0 TSI SHOWN)
TOOLS REQUIRED:
1 – 10mm WRENCH
1 – 13mm WRENCH
1 – DREMEL OR CUT-OFF WHEEL 1 – SMALL SCREWDRIVER
1 – NEEDLE NOSE PLIERS 1 – MEDIUM SCREWDRIVER
1. Open engine hood. ECU is located
under plastic cover at base of
windshield.
2. Remove the plastic cap that covers
the nut on both windshield wiper arms.
3. Remove the 13mm hex nut that holds
on the windshield wipers.
4. Lift wiper up and down to wiggle off
from tapered pin to remove.
5. Pull forward rubber sealing strip off
edge of firewall.
6. Carefully lift the plastic cover
perpendicular to windshield to detach
from the base of the windshield.
7. Unclip harness on passenger side..
8. Unclip ECU wire harness from fire
wall.
9. Unbolt and remove the upper firewall,
there is a 10mm hex nut on the driver’s
side and a 10mm hex bolt on the
passenger side.