Neuspeed 62.10.94 - Manual

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com
POWER PULLEY KIT
2014-UP Audi A3(8V) 1.8/2.0 TSI and 2015 VW GTI 2.0 TSI
PART # 62.10.94
INSTALLATION INSTRUCTIONS
PART LIST: 1 – CRANKSHAFT PULLEY 1 – BELT
1 – CRANKSHAFT BOLT
TOOLS REQUIRED: 1 – 16mm Wrench 1 – Ratchet Wrench
1 – T25 Torx 1 – VW Tool T10355 Counter Holder
1 – 24mm Socket 1 – Torque Wrench
1 – Long Handle Breaker Bar
NOTE: FACTORY TOOL REQUIRED AND PROFESSIONAL INSTALLATION RECOMMENDED.
1. Car Hoist required, vehicle not high enough from
ground with a jack or jack stands. NOTE: VW
GTI shown.
2. Remove passenger side wheel, then remove
lower engine splash guard. (8) T25 Torx screws.
3. Underneath bottom corner of bumper cap
remove the (2) T25 Torx screws.
4. Remove the lower half inner fender liner. (4)
T25 Torx screws.
5. Before removing ribbed belt, mark running
direction with marking pen if the stock belt and
pulley is ever to be re-installed.
6. Using a 16mm wrench, rotate idler pulley center
bolt upwards to release tension and remove
ribbed belt. Now slowly release belt tensioner.
7. Using the 24mm socket on crankshaft pulley
bolt, rotate engine clockwise to the “TDC”
position (Top Dead Center).