NM Engineering 258856 User Manual

NM Engineering For the car

Advertising
background image

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX

[email protected] ∞ www.nm-eng.com

 
 
 
 






PARTS INCLUDED:

[1] 22mm Adjustable Rear Sway Bar [2] Billet Aluminum Sway Bar Clamps [2] Graphite Impregnated Urethane Bushings [4] M8 x 25mm Socket Cap Bolts
[1] Synthetic Grease


TOOLS & SUPPLIES REQUIRED:

[1] Vehicle Jack

[2] Jack Stands

[1] Ratchet Handle [1] 18” Extension

[1] 17mm Wheel Lug Wrench [1] 13mm Socket

[1] 16mm Wrench

[1] 18mm Wrench or Socket

[1] 5mm Hex Key Wrench

[1] 6mm Hex Key Wrench

1. Park vehicle on a flat, level surface capable of supporting the

vehicle’s weight on jack and jack stands.

2.

Loosen rear wheel lug bolts.


3. Using the manufacturer’s recommended lifting points, raise

rear of vehicle and support with jack stands. Remove rear
wheels.

WARNING: NEVER WORK UNDER A VEHICLE

SUPPORTED ONLY WITH A JACK – SERIOUS INJURY OR
DEATH CAN OCCUR!

4.

Detach brake line and ABS wire from rear shock absorbers.

5. Unbolt and remove lower shock absorber bolt using 18mm

wrench.

6. Unbolt and remove [2] upper shock mount bolts using 13mm

socket and 18” extension. Remove shock and repeat for other
side.

7. Disconnect end-link from original anti-roll bar by securing stud

with 6mm hex key wrench and loosening nut with 16mm
wrench. Repeat for other side.

8. Remove the bushing clamp mounting bolts [2] using a 13mm

socket. Remove clamp and bushing. Repeat for other side.

9. Unbolt and remove [2] right-side vehicle sub-frame bolts.

Loosen the [2] left-side sub-frame bolts ½” or 13mm. Do NOT
remove left-side sub-frame bolts

.

10. From right-side of vehicle, push out original anti-sway toward

left-side of vehicle between uni-body and sub-frame.

11. Now from left-side of vehicle completely remove original bar.

12. Install NM anti-roll bar in reverse of removal of original bar.

HINT:

Leave plastic wrap on bar to protect finish of bar during

installation thru sub-frame then remove.

22mm ADJUSTABLE REAR ANTI-SWAY BAR – NM.258856

[R55] MINI Cooper Clubman 2008-up [Including Cooper S]
[R56] MINI Cooper Hardtop 2007-up [Including Cooper S]
[R57] MINI Cooper Convertible 2009-up [Including Cooper S]

Advertising