NM Engineering 488856 - Manual

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
[email protected] ∞ www.nm-eng.com
PARTS INCLUDED:
[1] Aluminum Pipe
[1] 90° Silicone Hose [1] Custom Silicone Hose [1] #28 Hose Clamp
[3] #40 Hose Clamps
TOOLS & SUPPLIES REQUIRED:
[1] Vehicle Jack
[2] Jack Stands [1] ¼” Ratchet Handle [1] 6” ¼” Extension
[1] 7mm Flex Socket [1] Screwdriver [1] 7mm Nut Driver [1] 8mm Nut Driver
[1] T25 Torx [1] WD-40
1. Park vehicle on a flat, level surface capable of supporting the
vehicle’s weight on jack and jack stands.
2. Using the manufacturer’s recommended lifting points, raise
front of vehicle and support with jack stands. WARNING:
NEVER WORK UNDER A VEHICLE SUPPORTED ONLY
WITH A JACK – SERIOUS INJURY OR DEATH CAN
OCCUR!
3. Loosen turbo discharge hose clamp (7mm hex) and
disconnect hose from turbocharger.
4. Remove 8mm hex screw that retains coolant reservoir tank.
Rotate back side of tank up to release lower pin mount, then
lift tank off top retaining tabs. Lay tank to the side.
5. From underneath the vehicle, remove the T-25 Torx mounting
screw that holds intake muffler to radiator fan shroud.
6. Loosen clamp (7mm hex) at lower pressure hose to
intercooler; now remove hose and muffler downward from
vehicle.
7. Attach custom silicone hose with suppled #28 hose clamp to
turbo; do not tighten at this time. Temporarily remount coolant
tank.
NOTE: Coolant hose runs above lower pin mount.
8. Rotate custom silicone hose so that there is about a 3/8”
clearance between it and the coolant hose. Then tighten hose
clamp (8mm hex).
9. Slide supplied #40 hose clamp onto custom silicone hose.
10. From underneath vehicle install aluminum pipe (longer straight
section goes up). Use WD-40 on pipe ends for easier fitment.
11. Rotate pipe for correct position, bottom opening of pipe should
be parallel to the ground and there should be no interference
with any other vehicle components.
12. Install 90° silicone hose with supplied #40 hose clamps.
NOTE: Slightly longer straight section on hose goes toward
intercooler.
13. Now tighten 90° silicone hose clamps (7mm hex). Double-
check pipe for proper clearances from top to bottom.
HI-FLOW TURBO DISCHARGE PIPE – NM.488856
[R55] MINI Cooper Clubman 2008-up [Including Cooper S]
[R56] MINI Cooper Hardtop 2007-up [Including Cooper S]
[R57] MINI Cooper Convertible 2009-up [Including Cooper S]