NM Engineering 658856.2 - Manual

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
engineer@nm- eng.com ∞ www.nm-eng.com
PARTS INCLUDED:
[1] Stainless Steel intake pipe bracket
[1] Stainless Steel fresh air hose bracket [1] Silicone turbo inlet hose [1] 2.75” Silicone coupler
[1] Aluminum or Carbon Fiber Air intake pipe [1] Air filter [3] #44 Hose clamps [1] #28 Hose clamp
[2] SS Button head bolts M6 x 16mm [1] SS Button head bolt M6 x 10mm [2] M6 Lock nuts [2] M8 Lock nuts
[2] M8 Washers [1] Aluminum Breather Tube Adapter [1] #16 Hose Clamp
TOOLS & SUPPLIES REQUIRED:
[1] T25 TORX Driver
[1] T30 TORX Driver [1] 7mm Nut Driver [1] Screwdriver
[1] 10mm Socket or Wrench [1] 13mm Wrench [1] 4mm Hex key wrench [1] Needle nose pliers
[1] Degreaser or contact cleaner [1] Clean shop rag
1. Squeeze the locking collar then pull-off breather hose to
disconnect from cylinder head cover.
2. Remove the wire harness support mounts from the air intake
tube.
3. Use screwdriver to loosen clamps at turbo inlet and at MAF
sensor. Remove air intake tube.
4. Squeeze locking tab then disconnect electrical connector
from Mass Airflow Sensor (MAF).
5. Separate brake booster line holder from fresh air intake hose.
Use needle nose pliers to squeeze tabs and then push out
holder.
6. Remove T25 TORX screw located on passenger side of air
filter box and lift off. NOTE: There are [3] pin mounts that are
pushed into rubber grommet mounts on intake manifold, so
effort may be required to lift air filter box off of mounts.
7. Locate fresh air pipe that is attached to air filter box.
Disconnect fresh air pipe by rotating the 90° connection
counter clockwise and pulling pipe away from air filter box.
Remove air filter box from vehicle.
8. Remove MAF sensor from air filter box by removing [2] T30
TORX screws.
9. Install MAF sensor to NM stainless steel intake pipe bracket
using supplied M6 x 16mm button head bolts and M6 nuts.
[4mm hex key wrench / 10mm socket or wrench]
HI-FLOW INDUCTIONS KIT*
– NM.658856.2 / B.2 / C.2
[R55] MINI Cooper S 2011 – Up N18
[R56] MINI Cooper S 2011
– Up N18
[R57] MINI Cooper S 2011 – Up N18
*For vehicles with Mass Airflow Sensor * NOT for US, Canada, and South Korean spec cars. Please use NM.658857.