NORAC UC4.5-BC-HD4 Part 1 - Manual (Page 27)

24
Figure 23: J1, J2 and J4 on HARDI DAH Board
Do not connect spade connectors to J1 & J2 until step 8.
8. Run the free end of C12A through an unused hole of the electronics enclosure. This
requires installing the Liquidtight connector (Pt. HARDI04, HARDI05) BEFORE proceeding
to step 9.
9. Put pins of C12A to the 6-pin and 4-pin Weatherpack connectors (S6 and S4) which are
included in this kit according to the table below. One connector on harness C11 may by
unused. Seal the unused connector with a 6-pin plug (C13).
The wire colors and the pin-out are the same as ones on the mating connectors
(T6 and T4) of the extension cable (C11).