Cobra Electronics 29NW ST - Manual (Page 7)

Rotate the On/Off Volume knob clockwise
the green RT/TX LED will be illuminated.
Repeat the same steps two through five on
Channel 1 and 40. This will check SWR for all
channels.
The S/RF-SWR-CAL switch must be in the
S/RF position to read the meter.
6
While still holding down the mic button,set
the S/RF SWR CAL switch to the SWR position,
to read the SWR reading. 5
Operation
13
Operation
12
1
Note
When switched to SWR posi-
tion the meter needle should
ideally be as far to the left as
possible. Anything over 3 is
not acceptable. A slight
antenna height adjustment
(higher or lower) may be
required. Repeat relcalibration
steps.
S-Meter S-Meter
Swings proportionately to strength of incoming
signal when receiving.
Switch to NOR to select desired channel. 1
Selecting A
Channel Selecting A Channel
Note
Switch to 9 (Emergency) or 19
(Information) for instant access
to these channels.
To Receive
1
To Receive
29 NW ST manual3.3 6/15/99 12:50 PM Page 12