NORAC UC4.5-BC-NT3 - Manual (Page 20)

17
Figure 17: Valve Cable configurations Outside of Cab
8. Connect the 6-pin shroud of the valve extension cable (C04) to the 6-pin tower of C10.
The valve extension cable (C04) is packaged with one end not installed. This is
for installation on other sprayer types. Install the included connector as per
the drawing in Section 10. If a mistake is made, use the pin pusher tool
supplied to remove the wires.
If the sprayer has the quick disconnect option, also install the valve disconnect
cable (C02) between C04 and C03.
9. Route C06 and C04 to the front of the sprayer, in the vicinity of the valve block.
10. Connect the valve cable (C03) to C04. Connect the 2-pin connectors on C03 to the
NORAC valve block, as shown in Figure 18.
11. The connectors on the valve cable (C03) are marked RIGHT UP, LEFT UP, RIGHT
DOWN and LEFT DOWN. Cables labeled with UP go on the same side as the
hydraulic hoses.