NORAC UC4+BC+TA1 - Manual (Page 18)

15
4.4 M
AIN
L
IFT
S
ENSOR
I
NSTALLATION
1. Assemble the main lift sensor bracket (B11)
as shown in Figure 13.
Figure 13: Main Lift Sensor Bracket
2. The bracket can be mounted to the lowest
frame member on the center section of the
sprayer. The bracket should be mounted so
the sensor mounting collar is approximately
in the center of the sprayer and ahead of the
boom (Figure 14 and Figure 15).
The sensor mounting collar must not
be behind the sprayer’s wheel.
The General Mounting Rules for
UC4+ Ultrasonic Sensors, from the
previous section, must be followed.
Figure 14: Main Lift Sensor Bracket
Mounting Position
3. Mount the sensor onto the sensor
mounting collar (Figure 14).
Figure 15: Main Lift Sensor Mounted in
the Correct Location
Bracket Tube
Sensor
Mounting Tab
Sensor Mounting
Collar
Bracket Base