NORAC UC4+BC+HG1 - Manual (Page 18)

15
4.4.2 Hydraulic Plumbing
WARNING!
From this point in the installation the
booms will be inoperative until the
electronics are fully installed.
After the NORAC valves are mounted, the
hydraulic hoses and fittings can be plumbed.
The plumbing for the hydraulic circuit is
shown schematically in Figure 3.
The “B” lines of the NORAC
valve block must be connected to
the Hagie “raise” lines.
Ensure there are no other
orifices present between the
NORAC valve block and the
boom cylinders.
You must ensure no hydraulic
components will interfere with
any sprayer parts or be pulled
tight at any time.