NORAC UC4+BC+MS - Manual (Page 14)

11
4.3 R
OLL
S
ENSOR
I
NSTALLATION
Mount the roll sensors to the included roll
sensor brackets using the machine screws
and nylon lock nuts. (Figure 13)
Figure 13: Roll Sensor Mounting
Bracket
4.3.1 Boom Roll Sensor Mounting
1. The boom roll sensor (E04) must be
mounted to the rotating part of the
boom. Ensure the cable is facing the
right hand side of the sprayer (when
looking from the rear of the sprayer).
4.3.2 Chassis Roll Sensor Mounting
1. The chassis roll sensor (E03) must be
mounted to a non-rotating part of the
boom. Ensure the CAN-bus cable is
facing the right hand side of the sprayer.
2. Fasten the temperature probe on the
chassis roll sensor to the UC4 valve
block using the included 3/8x1/2” bolt.
Figure 14: Temperature Probe
Figure 15: Boom and Chassis Roll Sensors (MS Sprayer)
E04
E03