NORAC UC5-BC-AP03 - Manual (Page 27)

24
10.2 Valve Block Mounting
1. A suitable mounting location for the valve block is illustrated in Figure 27.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 27: Valve Block Mounting
Valve Block and
Valve Module