Chicago Electric 94282 - Manual (Page 12)

SKU 94282 For technical questions, please call 1-800-444-3353 PAGE 12
IMPORTANT: If wet vacuuming, make sure to turn off and unplug the unit frequently
during use. Remove the Upper Cover (3) and empty the water in the Tank (15).
Once empty, replace the Upper Cover onto the Tank. Plug the unit’s Power Cord
(30) back into its electrical outlet, and turn on the unit to resume vacuuming.
NOTE:
The unit has a built-in float valve which, when the Tank becomes full of water, will
automatically turn off the unit. To restart the unit, follow the instructions previously
mentioned above.
When finished vacuuming, turn the Power Switch (2) to its “OFF” position. Then,
disconnect the Power Cord (30) from its electrical outlet. (See Figure G.)
To Use As A Blower:
CAUTION! Never use the Floor Nozzle (104) or Crevice Tool (106) when using
the unit as a blower. (See Figure G.)
IMPORTANT: Before using the unit as a blower, make sure to remove the Foam
Filter (107), Dust Bag (108), and Dry Filter (109) from the Filter Basket (21) and
Suction Port (13). Failure to do so may overheat and damage the Motor.
(
See Figure F.)
Connect the larger end of the Hose (110) to the Blower Port (4) of the unit. Next,
connect one or more Extension Wands (105) to the smaller end of the Hose.
(See Figure G.)
Plug the unit’s Power Cord (30) into the nearest 120 volt, grounded, electrical outlet.
(See Figure G.)
Then turn the Power Switch (2) of the Vacuum Blower to its “ON” position to begin
blowing. (See Figure G.)
When using the unit as a blower, DO NOT aim the Hose (110) or Extension Wands
(105) toward yourself or another person. (See Figure G.)
When finished using the unit as a blower, turn the Power Switch (2) to its “OFF”
position. Then, disconnect the Power Cord (30) from its electrical outlet.
(See Figure G.)
6.
7.
1.
2.
3.
4.
5.
6.
7.