NORAC UC5-BC-JD11 - Manual (Page 29)

26
10.2 Valve Block Mounting
1. A good mounting location for the valve block on the John Deere 4630 sprayer is illustrated
in Figure 28.
2. Mount the valve block with the “P” and “T” ports facing upwards.
3. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
4. Use the remaining hardware to secure the block to the sprayer.
5. Cut off excess threaded rod, if necessary.
Figure 28: Valve Block Mounting