NORAC UC5-BC-RG10 - Manual (Page 19)

16
8 Module Installation
8.1 Control Module
1. Refer to Figure 1 and Figure 14.
2. Securely mount the control module (E01) inside the electrical box in the electrical box
(Figure 15).
3. All cables that connect to the control module are located in the electrical box.
4. Connect the cable marked “NORAC C1” to the end of the control module with only one
Deutsch connector.
5. Connect the cables marked “NORAC C2” and “NORAC C3” to the control module
CANbus connectors.
Figure 14: Control Module Mounting