NORAC UC5-BC-VS01 - Manual (Page 23)

20
Figure 21: Valve Module Bracket Installation
5. Connect the valve module CANbus to cable C01 from the control module. Route cable
C02 from the other CANbus connector to the input module.
6. With the valve module securely mounted to the valve block, connect the valve cables (C10),
to the valve coils. Insert the 2-pin plugs (P01) into the unused 2-pin connectors on the
valve module.
7. Connect the temperature probe to the valve block using the supplied 3/8” x 1/2” hex bolt.
Figure 22: Valve Module Installation
Tank Port
Pressure Port
Sense Port
Left Tilt Ports
Right Tilt Ports