NORAC UC4.5-BC Quick Guide - Manual (Page 15)

12
 The control panel will automatically move the booms to detect and assign the sensors to
the correct locations.
 Release the button to continue.
Boom Geometry Tuning:
 Exit the cab and manually push either boom tip down 1 – 3 feet (30 – 90 cm) for a moment
and then let go.
 Do not walk near the sensors when approaching the boom. Stay at least 3 feet from the
sensor so as not to induce a measurement error.
Note: This step may not be applicable for all sprayer types.
Hydraulic Tuning:
 Hold the button to continue the hydraulic tuning. If is released before "Done" is
displayed, simply press and hold again to continue the procedure.
 The panel will display various messages as it is working. The messages are displayed for
informational purposes only.
 Release the button, the hydraulic tuning is complete.
Done
“Done”
Until Auto Hold
& let go ground near to
boom tip push Exit Cab
Switch Release