Oakworks 300 Series Procedure Chair Rev.B - Manual (Page 12)

Slide out the Procedure Tray
by pulling on the center slot
of the tray holder until the
tray stops. After a procedure
is performed, remove the
Procedure Tray with both
hands at the side notches
from the tray holder. Discard
fluids, clean and place back
into tray holder.
CleAnInG AnD DISInfeCTInG InSTRUCTIOnS
If fluid spill under the seat cushion, follow these instructions:
1. Remove the seat pad by pulling
up from the edge. The pad is held
on by Velcro.
CAUTIOn
PROCeDURe TRAy USe
Make sure the Leg Rest is fully lowered before using the procedure tray. Do not sit or push on
the Procedure Tray when extended from the seat. Maximum Weight rating of 15 lbs. (6.8 kg.)
2. Pull out the 2 pins on both sides
of the metal plate near the end of
the Procedure tray holder. Slide
the tray holder and Procedure
Tray out from the seat section.
3. Unscrew the 4 black handles at
the corners of the metal plate. Slide
the metal plate off from the seat
section and disinfect all surfaces.
9
DIReCTIOnS fOR USe
fIxeD T-RAIl
The Fixed T-Rail can be on one or both sides of the seat section, allowing the use of any t-rail accessory
with a Maximum Load Capacity of 150 lbs. (68 kg.)
Clamp & pole
not included.