Oakworks Cabana Lounger - Manual (Page 6)

ASSEMBLY
ASSEMBLY
3
PARTS
INCLUDED:
2 - Plastic Caps 4 - Acorn Nuts 8 - Hex Nuts
1 - Table
4 - Legs (2 of each)
Locate the pack of legs &
hardware and set aside.
step 1
Remove packing material.
step 2
Obtain one leg. Line up leg bolt
with one metal corner bracket.
Check that the small pull pin on the
leg is pointing to the inside
of the table. (see picture)
step 3
Place a split lock washer and hex
nut on each bolt. Hand tighten,
making sure that the leg fits
securely into the corner of the skirt.
step 4
8 - Split Lock
Washer
TOOLS REQUIRED: 1/2” open end or box end wrench
9/16” open end or box end wrench
small pull pin