Oakworks Stool Assembly - Manual

Part no. MMINUP0003
Parts Included:
1 - 5-Point Base 5 - Casters 1 - Adjustable Cylinder 1 - Stool Seat
Stool Seat
Plate
Backrest Flange
Seat Tube
Parts Included:
1 - Backrest
Support Knob
1 - Backrest
Backrest
knob
1 - Backrest
Support
Stool end
Backrest end
Fig. 1
Fig. 5
Fig. 6
Fig. 7
Fig. 2
Fig. 3
Fig. 4
Instructions for Stool Assembly:
Stool Assembly Instructions
Toll Free Phone: 800-558-8850 Phone: 717-235-6807
FAX: 717-235-6798
www.oakworks.com
OAKWORKS
®
, Inc.
923 East Wellspring Rd.,
New Freedom, PA 17349
1. If a black safety cap is present on the cylinder (see parts above),
remove the cap before assembling. Place the button end of the
adjustable cylinder into the opening in the seat tube. (Fig 1) Use
minimal force to press the cylinder into the seat tube. (Fig. 2)
2. Press one caster into each of the ends of the five-point base. (Fig. 3)
3. Set the black-metal end of the adjustable cylinder into the seat tube
in the five-point base. (Fig.4)
4. Use minimal force to press the adjustable height cylinder into the
base. Carefully sit down on the seat until the cylinder locks into
place. The seat will be tipped 2 degrees toward the back.
5. Using the lever under the seat, you can adjust the seat to the height
that’s best for you.
• You need to weigh at least 90 lbs. to adjust the height of the seat.
1. Turn the stool on its side and insert the stool end of the backrest
support into the backrest flange. (Fig 5) Slide the backrest support
knob through the slot on the flange and into the threaded hole in
the backrest support. Tighten the knob firmly. (Fig. 6)
2. Remove the backrest support knob and slide the backrest end of the
backrest support into the fixture on the back of the backrest. Tighten the
backrest knob just firmly enough to hold the backrest securely in place.
(Fig.7)
Troubleshooting:
• If the height adjustment lever will not work, the button on the
adjustable cylinder is not pushed into the seat tube completely.
Push down on the padding of the stool to seat the cylinder
more firmly in the seat tube.
Instructions for installation of Optional Backrest:
(Be sure to remove black safety cap
before assembling)