Oberon 1077-CP - Manual

Installation Instructions
Model Number 1077-CP
(877) 867-2312 • www.oberonwireless.com
Rev. A1 05/23/13 Oberon, Inc. •••• 1315 South Allen Street •••• State College, PA 16801 Copyright 2013
Figure 1
Figure 2 – Exploded door view.
Assembly Components:
- Ceiling enclosure Model 1077-CP assembly – 1 each
- Universal T-Bar Mount – 1 each
- 3/4” Trade Size Cable Clamp – 1 each
- Fire Block Foam – 1 each
- Support wire – 4 each
- Keys for access door lock – 2 each
- Installation Instructions – 1 each
If any of these items are missing, contact your Oberon representative.
Find a flat work surface to assemble the ceiling enclosure, access point and antenna(s) prior to mounting in ceiling.
Step 1 – Place the ceiling enclosure assembly on the work surface with the keyed doorway unlocked. Remove hole knock
outs located on the outside edge of the back box to install conduit connectors. Install one conduit connector if using P.O.E. or
install 2 conduit connectors if bringing in power and Ethernet and power separately (Figure 1).
Page 2
Step 2 – Unlock and open the door. Use the manufacturers T-Bar mount clip to attach the access point to the T-Bar Section
on the mounting plate. An additional mounting plate provided by the manufacturer of the access point may be needed to
attach the access point (Figure 2). Data cable(s) may need to be plugged in to the access point prior to attaching to the
mount. Cisco access points use Cisco AIR-AP-BRACKET-2 for 2600/3600 series access points and AIR-AP-BRACKET-
1 for 1140/3500 series.
Step 3 – The enclosure is ready to be placed in the ceiling.
Page 3
This product is Listed by Underwriters
Laboratories Inc. Representative
samples of this product have been
evaluated by UL and meet applicable
safety standards.
File #E348543