Oberon 1074-06-VENT - Manual

Installation Instructions
Model Number 1074
(877) 867-2312
•
www.oberonwireless.com
Rev. B 08/08/2014 Oberon, Inc.
•
1315 South Allen Street
•
State College, PA 16801 Copyright 2011
Assembly Components:
- Ceiling enclosure Model 1074 assembly – 1 each
- Electrical Junction Box – 1 each
- Electrical Receptacle – 1 each
- Electrical Receptacle Cover – 1 each
- Small Fire Block Foam Kit – 1 each
- Large Fire Block Foam Kit – 2 each
- Self Drilling Screws – 4 each
- Support wire – 8 each
- Keys for access door lock – 2 each
- Wire Management J-Hook – 4 each
- Installation Instructions – 1 each
If any of these items are missing, contact your Oberon representative.
Find a flat work surface to assemble the telecom ceiling enclosure and any other network/cellular components prior to
mounting in ceiling.
Step 1 – Place the telecom ceiling enclosure assembly on the work surface with the door facing up and keyed doorway
unlocked. If applicable, remove fiber ingress knockouts (Figure 1) located on the outside edge and back of the box (near key
lock) and install CCH style fiber optic adapter panel according to the manufacturer’s specifications.
Step 2 – Attach the electrical junction box to one of the knockouts located on the bottom of the enclosure (Figure 2) with four
self drilling screws.
**IMPORTANT** - The electrical junction box must be attached to the back box with all four (4) screws for it to be
grounded properly. A power supply outlet MAX 125VAC, 20A should be used.
Page 2
Step 3 – If using the optional rack mounting brackets
(Oberon P/Ns 1611 and 1612, not included), adjust the
position of the mounting brackets to allow the
equipment power cord to be plugged into the
receptacle. Install all rack mounted equipment to the
mounting brackets with four (4) #10-32 screws. The
maximum height the enclosure can accommodate is
2U and the maximum length is 14”. The mounting
brackets can be repositioned to fit networking
equipment of various lengths (Figure 3).
Step 4 – (Only for Model 1074-ANT7) If attaching
wireless access points or cellular devices use the
optional T-Bar Bracket (Oberon P/N 1972 not
included). Mount the access point to the bracket per
the manufacturer's directions. Remove hole plugs to
attach antennas to the door of the enclosure (Figure 4).
The assembled unit is now ready for ceiling installation.
Step 6 – Use wire rope support cables (included) to support the telecom enclosure. Attach one end of the wire to the eye tabs
located along the edge of the back box and the other end to a permanent structural component of the building such as a joist.
A supporting grid wire should be attached to all four corners.
**IMPORTANT** - This is an important safety feature that could prevent human injury or damage to the equipment
should the unit become dislodged from the ceiling.
Page 3
Figure 3
Figure 1
Figure 2
Figure 4
Optional Step – Fasten the provided j-hooks to
the backside of the enclosure for cable
management.
Figure 5